Cleaning Guide
Removal
Follow these instructions to safely and quickly remove your Lash Ribbons from your natural lashes with no damage to either.
DO NOT THROW AWAY YOUR SEGMENTS AS THESE CAN BE REUSED OVER AND OVER AGAIN (UNLESS YOU HAVE PURCHASED THE ECONOMY RANGE OF RIBBONS)
Step 1
Once you are ready to remove your lashes use our Remove'Em (if you do not have this you can also use Baby Oil, Coconut Oil or a Dual Phase Makeup Remover)
Step 2
Apply a generous amount of the remover to both the top side and underside of your lashes and leave for a couple of minutes to soak into your lashes
Step 3
Remove the segments from your natural lashes either with your applicator or fingers. The segments should easily slide off your natural lashes - never tug to remove them - just apply more remover if they are not easily coming off. The remover will also remove any residual glue from your natural lashes
Cleaning
Step 1
You will need some Isopropyl Alcohol (also known as Rubbing Alcohol) - minimum 97% proof (readily available on Amazon/Ebay)
Step 2
You will also need a container with a lid
Step 3
Pour a small amount of the alcohol into your container
Step 4
Place your used lash ribbon segments into the alcohol
Step 5
Close the lid and leave to soak
Step 6
You can leave the segments to soak for a couple of hours or a few days
Step 7
Remove the lash segments and place on absorbent paper
Step 8
With a soft brush gently tease the remaining glue off the segments - do not tug the lashes
Step 9
Leave the clean lash segments to air dry for a few minutes
Step 10
And finally give them a quick brush up with a spoolie and they are now ready to rewear. This process can be used several times on your Lash Ribbons so you can get optimal wear from them